Charging The Battery - RealTrace Mini Reader RT10M User Manual

Scanning for an animal tag
Push the button. Scan slowly the area where a microchip is expected to be found while keeping the reader for a few
centimeter's distance from the animal's skin. The reader will be scanning for about 20 seconds. The blue light flash, the
display is black.
If a tag is detected the reader will "beep" and the identification number is displayed as follow:
XXX xxxxxxxxxxxx
XXX = country ISO code or manufacturer code (3 figures)
xxxxxxxxxx = individual identification number, (12 figures ).
If no microchip has been found after 20 seconds searching, the following message will be displayed on the screen. The LCD
screen will stop displaying the message after about 15 seconds.
No tag found!
If this situation arises, try finding the microchip again. To do so you must re-activate the reader by pressing the button.
Scan the possible microchip implantation area with as large and sweeping movement as possible. If necessary, repeat the
operation after having re-activated the reader again.

Charging the battery

Directly connected to PC USB the Mini Reader will be charging automatically .
Red light when in charging, green light when charge is complete.
Remarks: when the battery LI-Ion is low powered, the key reader may not read any tag or can read in a very short
distance. If the temperature is lower than 10° the reading range will be decreasing.
2