Placing the device in operation
Caution!
Transport securing screws
Ensure that the transport securing screws at the
top side of the device are removed before the
startup of the de-vice.
Press and release [
the unit on.
Press and hold the [
the unit on.
Note:
The unit will power on in the same state it was
Mute
Press the [
] button to mute the sound.
Note:
• Pressing the [
] button again or adjusting
volume will unmute.
Adjust the Volume
Press the [
] or [
decrease the volume level.
The adjustable range of volume is 0 to 40.
Playing Source Selection
Press the [
] button on the panel to show
main source menu.
Touch desired icon on the the screen to
enter corresponding working mode, such as
Disc, Navi, Radio, etc.
Drag left/right to scroll.
Note:
• When some devices are not ready, they cannot
be selected.
• You should stop switching when the playing
source you desired has been selected and wait
for some seconds, the unit will auto enter the
playing source mode you have selected.
When Vehicle is Put in Reverse
If the rear view video camera is connected, the
unit automatically switches to CAMERA source
during reverse driving. The unit returns to the
previous source after the vehicle has been taken
out of reverse.
/
] button to turn
/
] button to turn
] button to increase or
When Parking Brake Applied
If 'PRK SW' cable is connected to hand brake
switch, the video display of the TFT monitor
will be controlled by driving status, system
setup and input video sources.
When the car is moving forward, and a video
source is being played, the screen will display
a warning disclaimer and a blank screen. The
warning screen will prevent the driver from
watching images.
Main Menu
In the main menu, you press the buttons on the
operating modes.
Press the [
] button on the top left on the
screen to display the playing source menu.
1
3
2
1. Slide left or right for more selection
2. Playing source icon: Touch to access
corresponding work mode.
3. Return : Return to previous interface
4. Brightness control: Press to switch brightness
Setting the reception area
This car sound system is designed for operation in
and station technologies:
In the main menu, press the [
The Setup menu is displayed.
In the Setup menu, press the [ System ]
button.
Scroll down until "Radio area" is seen.
press the [ Radio area ] button to display
the list of available reception areas.
Press the [
] button. The main menu is
displayed again.
Startup
4
1
] button.
5