Table of Contents
Advertisement
IS-TWL-DEBUGGER Setup
3 Operation Environment
3.1 Requirements
The following components are required to operate IS-TWL-DEBUGGER.
Table 3-1 Operation Environment Requirements for IS-TWL-DEBUGGER
Component
Computer
Operating system
Memory capacity
Disc capacity
Disc drive
Display
USB interface
3.2 About USB 2.0
The IS-TWL-DEBUGGER device supports USB 2.0 high-speed (480 Mbps) data transmission. To take
advantage of all the IS-TWL-DEBUGGER features, make sure to observe the following cautions.
• Confirm that the computer is compatible with high-speed data transmission. If the computer does not
support high-speed USB, use a high-speed-compatible USB interface card.
• Make sure to use a USB cable that is compatible with high-speed data transmission to connect the
computer with the IS-TWL-DEBUGGER device. A high-speed-compatible USB cable is included with
IS-TWL-DEBUGGER.
• When using a USB hub to connect the computer to the IS-TWL-DEBUGGER device, make sure that
it is a high-speed-compatible hub.
• If the number of USB devices connected to the computer increases, the data transfer speed will go
down. To maximize the data transfer speed, make sure that the only USB device connected to the
computer is the IS-TWL-DEBUGGER device.
© 2008-2009 Nintendo
CONFIDENTIAL
PC/AT-compatible
One of the following 32-bit versions must be installed:
•
Microsoft Windows Vista, Service Pack 1 or later (32-bit version)
•
Microsoft Windows XP, Service Pack 2 or later (32-bit version)
As recommended by the operating system or greater; depending on the scope
of the project that you are developing, more memory may be required.
50 megabytes or more of free memory
Requires a drive that can read CD-ROMs for installation.
XGA display with a 1024x768 resolution or higher
One port (two ports when using the capture option)
USB 2.0 (high-speed) is recommended for high-speed downloads or video
capture
9
Description
Released: March 17, 2009
TWL-06-0024-001-E
Hide quick links:
Advertisement
Table of Contents
