Geist Watchdog Wi Instruction Manual page 61

System Location
V1/V2C Community Names When communicating via SNMP V1/V2, identify devices that
receive Traps and/or Syslog messages from the Watchdog Wi and communicate with the
Watchdog Wi over the network.
Get / Read
Set / Write
Trap
Traps
Trap Type
IP Version
Max. Inform Retries
Inform Interval
Trap Destinations
Trap Enabled
IP Address
SNMPv3 EngineID
User Name
Access Mode
No-Auth
Auth-MD5, No-Priv
Auth-MD5, Priv-DES
Auth. Password (8-24 chars) Enter the authentication password - the password must be
Priv. Password (8-24 chars) Enter the privacy (encryption) password - the password must
GM1212 Geist Watchdog Wi Instruction Manual
Enter the address of the Watchdog Wi 's physical location.
Enter the appropriate community name.
Enter the appropriate community name.
Enter the appropriate community name.
Select the SNMP version that best suits your needs:
V1 - Trap, V2C - Trap, V2C - Inform, V3 - Trap, or V3 - Inform.
Designate whether traps will be sent via IPv4 or IPv6.
If the communication of a trap fails, this is the maximum
number of times the Watchdog Wi will re-send the trap.
This is the amount of time that lapses between re-sends.
Check the box to allow a trap to be sent to the device defined
in this row.
This is the IP address of the device that the trap will be sent
to.
If this device uses SNMPv3, data will populate in this field.
Enter a unique name for each SNMPv3 user.
Choose from the following Watchdog Wi :
A user name is needed for No Authentication, and a user
name and password are required for Authentication and
Privacy Authentication access.
between 8 and 24 characters long.
be between 8 and 24 characters long.
Chapter 4 - Final Checkout 61
© 2017