Advertisement
Procedure
7
8
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key from
the switch.
2
Moving the Front Roller
No Parts Required
Procedure
1. Loosen the jam nuts and set screws securing
each end of the front roller to the height-of-cut
arms
(Figure
1).
Description
Bearing Adapter
Spacer
Groomer-plate assembly
Adapter ring
Bolt (1/4 x 3-3/4 inches)
Star washer
Fastener retainer
Weight
Groomer-shaft clamp
Socket-head screw (1/4 x 1-1/4 inches)
Groomer reel (obtain separately)
Qty.
1
2
1
1
Install the groomer on the right side of
the machine.
2
2
2
1
4
4
Install the grooming reel.
1
1
1. Height-of-cut arm
2. Jam nut and set screw
3. Carriage bolt, washer, and
locknut
2. Remove the carriage bolts and locknuts securing
the height-of-cut arms to the adjusting brackets
(Figure
1).
3. Remove the height-of-cut arms from the side
plates and roller assembly.
4. Remove the height-of-cut hardware as follows:
•
Greensmaster 1600 mowers—remove the
height-of-cut adjusting screws, jam nuts,
and set screws from the height-of-cut arms
(Figure
1).
•
Greensmaster 800 and 1000
mowers—remove the 2 taper-face
bolts securing the right and left height-of-cut
brackets to the side plates
the height-of-cut brackets to the opposite
2
Use
4
3
g017178
Figure 1
4. Height-of-cut adjusting
screw
5. Height-of-cut bracket
6. Taper-face bolt (bolt head
on the other side of the
side plate)
(Figure
1). Install
5
6
2
g017178
Advertisement
