Air Handling Unit - Air Master AM 900 H Installation Manual

3.3.

Air Handling Unit

Installation of an AM 900
1. Dismantle the floor panel of the unit.
2. Lift up the unit. on its adjustable feet.
NB! When lifting the unit, protection must be provided
for the height-adjustable feet to prevent breakage
or deformation. If necessary, insert a suitable block
of wood under the bottom edge of the unit before
lifting it.
3. Place the unit as close to the installation place as
possible. The unit can be moved to the place with
for instance a pallet loader.
4. Adjust the feet in a way, so the unit is at level.
5. Move the air handling unit to its final position so
that the duct connections fit into the holes without
touching the wall/roof. The unit can be moved to the
place with for instance a pallet loader.
6. Fit the floor panel.
7. Fit the brackets to the top of the air handling unit
and the wall.
8. Seal the gap between the air handling unit and the
wall by using a sealant that retains elasticity over
the long term.
Note the type, date supplied, place of installation and serial
numbers (S/N) of the air handling unit and the cooling
module on page 2 of both the Mounting Instructions, the
Installation Manual and the Operator's Manual.
7