Table of Contents
Advertisement
3.7.
Fitting of Panels (AM 1200)
The panels should not be fitted until the unit is complete
with all equipment, has been fitted and connected, and the
functions of the unit are thoroughly tested.
1. Fit all design panel mounting strips. 2 strips for large
design panels and 4 strips for small ones.
NB! The mounting strips with a vertical edge should be
fitted to the right side (see black arrows). The angels
should point upwards.
The top half of the unit shows the 2 mounting strips for
large design panels, the bottom half shows the 4 mounting
strips for small design panels - see white and black arrows.
2. Fit all the design panels on the angels of the unit,
the top strips and the extract panel set on the unit.
3. Fit the plinths.
3.8.
Installation Check
Data and serial numbers noted
Unit fitted
Angle brackets fitted
Pipes and grates fitted
Wall cover fitted
Roof cap fitted
Screws retightened
Name of installation engineer:
Comment:
10
yes no
Hide quick links:
Advertisement
Table of Contents
