Fueling & Lubrication; Chain Tension; Fueling Engine; Bar And Chain Lubrication - Poulan Pro 2250, 2450, 2550 Operator's Manual

Mount the Bar
Tip of Bar
Proper chain direction
Place chain onto the sprocket

CHAIN TENSION

(Including units with
chain already installed)
NOTE:
When adjusting chain tension,
make sure the bar nuts are finger tight only.
Attempting to tension the chain when the
bar nuts are tight can cause damage.
Checking the tension:
Use the screwdriver end of the combination
screwdriver/wrench tool to move the chain
around the bar. If the chain does not rotate, it
is too tight. If too loose, the chain will sag be-
low the bar.
Adjusting the tension:
Chain tension is very important. Chain
stretches during use. This is especially true
during the first few times you use your saw.
Always check chain tension each time you
use and refuel your saw.
You can adjust chain tension by loosening
the bar clamp nuts and turning the adjust-
ing screw 1/4 of a turn while lifting up on bar.
S If chain is too tight, turn adjusting
screw 1/4 turn counterclockwise.
S If chain is too loose, turn adjusting
screw 1/4 turn clockwise.
S Lift up the tip of the bar and tighten the bar
clamp nuts with the combination screw-
driver/wrench.
S Recheck chain tension.
Chain moves freely
Lifts only 1/8 of an inch from bar.
Adjusting
Screw
Bar Clamp Nuts
FUELING & LUBRICATION

FUELING ENGINE

This engine is certified to operate on
unleaded gasoline. Before
gasoline must be mixed with a good quality
2-cycle air-cooled engine
recommend Poulan/Weed Eater brand oil. If
you do not use this oil, use a good quality
2-cycle air-cooled oil designed to be mixed
at a ratio of 40:1 (A 40:1 ratio is obtained by
mixing 3.2 onces of oil with 1 gallon of
unleaded gasoline). When mixing fuel
follow the instructions printed on the
container. Always read and follow the safety
rules relating to fuel before fueling your unit.

BAR AND CHAIN LUBRICATION

The bar and chain require continuous lubri-
cation. Lubrication is provided by the auto-
matic oiler system when the oil tank is kept
filled. Lack of oil will quickly ruin the bar and
chain. Too little oil will cause overheating
shown by smoke coming from the chain
and/or discoloration of the bar.
In freezing weather oil will thicken, making it
necessary to thin bar and chain oil with a
small amount (5 to 10%) of #1 Diesel Fuel or
kerosene. Bar and chain oil must be free
flowing for the oil system to pump enough
oil for adequate lubrication.
Genuine POULAN or POULAN PRO bar
and chain oil is recommended to protect
your unit against excessive wear from heat
and friction. POULAN or POULAN PRO oil
resists high temperature thinning.
POULAN or POULAN PRO bar and chain oil
is not available, use a good grade SAE 30
oil.
S Never use waste oil for bar and chain lu-
brication.
S Always stop the engine before removing
the oil cap.
Oil Cap
6
Guide Bar
operation,
oil. We
If
Fuel mix cap