Table of Contents
Advertisement
If the Pyrolysis function
operates, the door is locked
and the symbol of a key
comes on in the display.
To deactivate the function, press
display shows a message. Press
and then
to confirm.
When you deactivate the
appliance, the function also
deactivates.
10.4 Set + Go
The function lets you set a heating
function (or a programme) and use it later
with one press of any symbol.
1. Activate the appliance.
2. Set a heating function.
3. Press
again and again until the
display shows: Duration.
4. Set the time.
5. Press
again and again until the
display shows: Set + Go.
6. Press
to confirm.
Press any symbol (except for
the function: Set + Go. The set heating
function starts.
When the heating function ends, an
acoustic signal sounds.
• Function Lock is on when
the heating function
operates.
• The menu: Basic Settings
lets you activate and
deactivate the function:
Set + Go.
10.5 Odour Filter
You can activate the function in the menu:
Basic Settings. It operates during baking
and roasting.
This function uses additional energy to
operate.
. The
10.6 Automatic Switch-off
again
For safety reasons the appliance
deactivates automatically after some time
if a heating function operates and you do
not change any settings.
Temperature (°C) Switch-off time
30 - 115
120 - 195
200 - 245
250 - maximum
) to start
10.7 Brightness of the display
There are two modes of display
brightness:
• Night brightness - when the appliance
is deactivated, the brightness of the
display is lower between 10 PM and 6
AM.
• Day brightness:
– when the appliance is activated.
– if you touch a symbol during the
– if the appliance is deactivated and
10.8 Cooling fan
When the appliance operates, the cooling
fan activates automatically to keep the
The filter cleans automatically
every 100 hours, even when
you deactivate it in the menu.
It is always active during the
pyrolytic cleaning.
(h)
12.5
8.5
5.5
1.5
The Automatic switch-off
does not work with the
functions: Light, core
temperature sensor, End
Time, Duration.
night brightness (apart from ON /
OFF), the display goes back to the
day brightness mode for the next
10 seconds.
you set the function: Minute
Minder. When the function ends,
the display goes back to the night
brightness.
ENGLISH
19
Advertisement
Table of Contents
