Operation - Poulan Pro 115358026 Instruction Manual

S If chain is too tight, turn adjusting screw 1/4
turn counterclockwise.
S If chain is too loose, turn adjusting screw
1/4 turn clockwise.
Adjusting screw
Chain Brake Nuts
Adjusting Screw - - 1/4 Turn
S Lift up the tip of the bar and tighten the
chain brake nuts securely with the bar tool.
S Recheck chain tension.
KNOW YOUR SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
CHAIN SAW. Compare the illustrations with your unit to familiarize yourself with the location of the
various controls and adjustments. Save this manual for future reference.
Chain Adjustment
Front Hand Guard
Tool
(Bar Tool)
Chain
Bar Sprocket
Hole
Cylinder Cover
Throttle
Lock- -out
Rear
Handle
Throttle
Trigger
Chain Brake
Choke/Fast
Idle Lever
ON/STOP SWITCH
The ON/STOP SWITCH is used to stop the
engine.
NOTE:
The chain is tensioned correctly when
the weight of the chain does not cause it to sag
below the guide bar (with the chain saw sitting
in an upright position), but the chain still moves
freely around the guide bar.
WARNING:
with a loose chain, the chain could jump off the
guide bar and result in serious injury to the op-
erator and/or damage the chain making it un-
usable. If the chain jumps off the guide bar, in-
spect each drive link for damage. Damaged
chain must be repaired or replaced.

OPERATION

Front Handle
Muffler
Bar Oil
Fill Cap
Starter Housing
Adjusting
Screw
Chain Brake Nuts
THROTTLE TRIGGER
The THROTTLE TRIGGER controls engine
speed.
8
Chain Brake
Nuts
If the saw is operated
Starter Rope
ON/STOP
Switch
Fuel Mix Fill Cap
Direction
of Chain
Travel
Guide Bar