Filter In The Water Supply Blocked - Bosch WOT24455BY Instruction Manual And Installation Instructions

Drainage hose on the siphon blocked
1.
Note: Residual water may run out!
2.
3.
4.

Filter in the water supply blocked

Check and clean the filter regularly (at least two to three times a
year).
1.
2.
3.
²
Do not immerse the hose in water.
4.
5.
²
Supply hose
– Regularly check for brittleness and cracks and replace if
– The Aqua-Stop supply hose (fig. left) has a safety valve that
– Depending on the model, the water stop supply hose may
– On supply hoses with a transparent covering, regularly check
Switch off the appliance. Pull out the mains plug!
Loosen hose clip, carefully remove drainage hose.
Clean drainage hose and siphon spigot.
Re-attach drainage hose and secure connection point with
hose clip.
Turn off the tap. Disconnect the mains plug.
Unscrew the hose from the tap.
Carefully clean the filter on the end of the hose with a small
brush (e.g. toothbrush).
Screw the hose back onto the tap. Do not use pliers.
Connect the mains plug.
necessary.
protects against the uncontrolled supply of water. If the
inspection window (see horizontal arrow) on this valve turns
red, the safety mechanism has been triggered. The hose
must be replaced
have an unlocking device (see horizontal arrow), which must
be pressed and held while the hose is being unscrewed from
the tap.
the colour of the covering. An intensification of the colour in
places indicates that there is a leak. The hose must be
~
replaced. After-sales service
~
after-sales service
19