Samsung GT-E2330B Service Manual page 27

7-2. Assembly
1
1) Set to UPPER's place guide rib and place
sub keypad
1) Confirm guide rib 2 points attach status
3
1) After set to place standards RIB and
place vertically FPCB, place receiver on
UPPER's placing area
2) Place MOTOR on UPPER placing area
2
1) Beware that you do not damage FPCB & WIRE
This Document can not be used without Samsung's authorization
1
SAMSUNG Proprietary-Contents may change without notice
2
1) Attach on upper from LCD's up
1) Keep in mind and work to crack by fog damage!
4
1) After turning over LCD PCB's right side
connector actuator lightly, insert
RCV+MOT ass'y FPCB depending on base
line
1) Beware that you do not damage FPCB
7-5
7. Level 2 Repair