Porter-Cable 745 Instruction Manual page 14

guide shoe to move freely. Adjust to desired position and securely tighten
both screws.
NOTE: Do not adjust the pivoting guide shoe out so far that it loses contact
with the back screw. Doing so will cause the guide shoe to be unstable.
After adjusting, make sure both screws are securely fastened.
The Models 746 and 748 are supplied with a keyless Quik-Change ™
2.
pivoting guide shoe. To adjust, rotate lever (A) Fig. 12B. releasing the
pivoting guide shoe (B). Adjust to desired position and close lever (A) Fig.
12C. The keyless Quik-Change ™ pivoting guide shoe is designed with a
raised lip (C) at the end that prevents the guide shoe from locking in position
if it is extended out too far. After adjusting, make sure the locking lever is
completely closed in the locked position (A) Fig. 12C.
NOTE: DO NOT force the locking lever closed. Adjust shoe enough to allow
the lever to lock in position without force.
A
Fig. 12
BEFORE YOU START TO WORK
Select the blade best suited for the material to be cut. For greatest economy,
use the shortest blade suitable for the thickness of the material to be cut.
A
Fig. 12A
14