Rack Mounting - Kontron RMX-KB104 User Manual

Installation
The RMX-KB104 rack mount keyboard drawer series is designed specifically for rack mount
enclosures or other types of industrial enclosures. This section describes how to install the
drawer into a 19" RETMA industrial rack.

Rack Mounting

Rack mounting consists of mounting the rails into an industrial rack and sliding the keyboard
into place. Two sets of rear brackets are included to allow mounting in racks from 17 to 30 inches
in depth. The installed brackets fit on 17 to 24 inch deep racks. For racks deeper than 24 inches,
remove the four screws holding the installed rear brackets in place and install the longer 24 to
30-inch rear brackets with the four screws:
Figure 2-1. RMX-BKB104 Assembly Drawing (Reference Only)
RMX-KB104 User's Guide
17''-24'' Rear Bracket
24'' - 30''
Rear Brackets
(Uninstalled)
17''-24'' Rear Bracket
Installation 2-3