Page 2
ENGLISH HELIOS ELECTRIC INFRARED IRK SAFE INDUSTRY MODEL 1500 Watt (cod. EH SAFE 15) / 2000 Watt (cod. EH SAFE 20) DIRECTIONS PLEASE NOTE: safe use of this equipment can only be ensured if the user complies with these directions. Users must therefore keep these directions at hand at all times.
Page 3
TRANSPORT Any damage noted after delivery of low voltage appliances must be immediately reported to the transport company. Do not set the appliance at work. Notify the technical support team for all controls required. VENTILATION Distance between the heater and wall or ceiling is to be as specified in the drawing on page 11. PLEASE NOTE: The appliance is certified for non-conductive combustible dust.
Page 4
IMPORTANT NOTICE: TO PREVENT OVERHEATING OF THE BULB, THE EXTERNAL SURFACE OF THE GLASS MUST ALWAYS BE KEPT CLEAN DISCONNECT POWER SUPPLY BEFORE CLEANING * Connect Helios Safe Industry to a 220-240V power source, single-phase, according to the country in which the appliance is used * Helios Safe Industry must be connected to an earth connection system * Check that the input power is appropriate for the electrical load to be installed...
Page 6
WALL INSTALLATION PLEASE NOTE - THE APPLIANCE MUST ALWAYS BE INSTALLED HORIZONTALLY, AS ILLUSTRATED IN THE DRAWING - ANCHORAGE/ REAR JOINT (DETAIL) - CEILING INSTALLATION...
Need help?
Do you have a question about the ATEX EHSAFE15 and is the answer not in the manual?
Questions and answers