Porter-Cable D25115-0112-0 Instruction Manual page 16

PUMP
This screen filter should be checked
periodically and cleaned if necessary.
1. Remove filter by grasping end
and removing it from water inlet
of pump as shown.
2. Clean filter by flushing it with
water on both sides.
3. Install filter into water inlet of
pump
Filter Screen
WAND
If the nozzle becomes clogged with
foreign materials, such as dirt, exces-
sive pressure may develop. If the
nozzle becomes partially clogged or
restricted, the pump pressure will pul-
sate. Clean the nozzle immediately
using the nozzle kit supplied and the
following instructions:
1. Shut off the pressure washer and
turn off the water supply.
2. Disconnect spark plug wire.
3. Pull trigger on gun handle to
relieve any water pressure.
4. Disconnect the wand from the
gun.
5. Remove the high-pressure nozzle
from the wand. Remove any
obstructions with the nozzle
cleaning tool provided and back-
flush with clean water.
6. Direct water supply into nozzle
end to backflush loosened parti-
cles for 30 seconds.
7. Reassemble the nozzle to the
wand.
8. Reconnect wand to gun and turn
on water supply.
9. Start pressure washer and place
wand into high pressure setting to
test.
16- ENG