Husqvarna 565 Operator's Manual page 31

Checking the inertia brake release
Place the chain saw, with the engine switched off, on a
stump or other stable surface. Release the front handle
and let the saw fall by its own weight, rotating around the
rear handle towards the stump.
When the bar hits the stump the brake should be
activated.
Checking the brake trigger
Place the chainsaw on firm ground and start it. Make sure
the chain does not touch the ground or any other object.
See instructions under the heading Starting and stopping.
Grasp the chainsaw firmly, wrapping your fingers and
thumbs around the handles.
Apply full throttle and activate the chain brake by tilting
your left wrist forward onto the front hand guard. Do not
MAINTENANCE
let go of the front handle. The chain should stop
immediately.
Throttle trigger lockout
• Make sure that the throttle trigger is locked at idle
setting when the throttle trigger lockout is released.
• Press the throttle lockout and make sure it returns to
its original position when you release it.
• Check that the throttle trigger and throttle lockout
move freely and that the return springs work properly.
• Start the chain saw and apply full throttle. Release the
throttle control and check that the chain stops and
remains stationary. If the chain rotates when the
throttle trigger is in the idle position, contact your
servicing dealer.
–
English 31