UBX UBR510B Instruction Manual page 11

INPUT MODES
1). Make sure that the media play/ TV is turned on.
2). Switch to AUX1 by pressing
3). Start playback on the connected media player/TV.
4). Adjust the master and/or surround speaker volumes as desired.
3. MP3/iPhone
Use a 3.5mm auxiliary cable to connect an audio player to the unit and send audio signals to the home
theatre speakers.
Example: iPhone connected to the unit using an auxiliary cable.
1). Make sure that the iPhone is turned on and has music ready to play on the iPod app.
2). Switch to MP3/iPhone by pressing
3). Start music playback on the connected iPhone.
4). Adjust the master and/or surround speaker volumes as desired.
4. Radio
Listen to radio stations using the in-built FM/AM tuner
FM/AM
1). Press the
FM/AM
2). Press the
SCAN +/-
3). Press the
Station Memory
1). To save preset stations, first tune to the desired station with the
MEMORY
2). Press the
3). Press the desired number for the station to be saved to.
Note :
The unit can save up to 11 stations on FM and 11 stations on AM.
5. Microphone
Connect up to 2 microphones to the unit and broadcast through the speakers. This can be done in any
input mode. The audio input from the microphones will be overlayed on any existing audio output and
can be used for karaoke, etc.
Example: Microphone to be connected to the unit using the jack on the front panel.
1). Connect the microphone first, then turn on the microphone's power.
2). Adjust the microphone volume using the master microphone volume dial or individual
volume dials as desired.
AUX1
on the remote control or main unit.
MP3/iPhone
button on the remote control or main unit to switch to FM/AM input
button again to toggle between FM and AM frequencies if desired.
buttons to adjust the frequency.
button.
on the remote control or main unit.
SCAN +/-
buttons.
10