Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the jumpshot and is the answer not in the manual?

Questions and answers

Summary of Contents for Lexar jumpshot

  • Page 2: Table Of Contents

    Installing the JumpShot Connectivity Kit ........2...
  • Page 3: Introduction

    Thank you for purchasing Lexar Media’s USB-Enabled JumpShot connectiv- ity kit, the easiest and quickest way to transfer digital photos from your camera to your PC or MAC. JumpShot permits you to read and write from your USB-Enabled CompactFlash card using the USB port of your computer.
  • Page 4: Installing The Jumpshot Connectivity Kit

    Installing the JumpShot Connectivity Kit Windows 98 Insert the Lexar Media JumpShot CD-ROM (Fig 1). Connect the JumpShot cable to an available USB port on your computer or USB hub (Fig 2). Insert the USB-Enabled CompactFlash card into the Figure 1 JumpShot cable (Fig 3).
  • Page 5: Using Jumpshot

    Using JumpShot Insert JumpShot cable into an available USB port (Fig 2). Insert CompactFlash card into JumpShot cable (Fig 3). The USB-Enabled CompactFlash card can now be used just as any other drive on your system. Removing the CompactFlash card from the...
  • Page 6: Understanding The Jumpshot Cable's Led Activity Indicator Signals

    NOTE: If the LED Activity Indicator does not turn on when a card has been inserted, this may indicate that the card is not supported in JumpShot. This card may not be an USB-Enabled CompactFlash card or that your USB- Enabled card is damaged.
  • Page 7: Minimum System Requirements

    Minimum System Requirements Windows 98 Windows 98 operating system with USB support 486 CPU or higher required; Pentium compatible or higher recommended One available USB port 16 MB or more RAM 5 MB of available hard disk space CDROM drive Macintosh MacOS 8.5 or higher One available USB port...
  • Page 8: Troubleshooting Your Usb-Enabled Compactflash & Jumpshot Cable

    Table 1: Windows SYMPTOM CAUSE CORRECTIVE ACTION The green LED Activity The JumpShot cable has come loose Reinsert the USB connector; make sure Indicator does not from the USB port or was not plugged the connector is firmly seated come on...
  • Page 9 Table 2: Macintosh SYMPTOM CAUSE CORRECTIVE ACTION The green LED Activity The JumpShot cable has come loose Re-insert the USB connector; make Indicator does not come from the USB port or was not plugged sure the connector is firmly seated...
  • Page 10: Technical Support

    Technical Support If you need assistance with installing or using your USB-Enabled Compact- Flash card and JumpShot cable, please contact Lexar Media Technical Support by any of the following means: Telephone Lexar Media USA 510-413-1275 Lexar Media Japan 03-3465-4175 03-3465-4060 fax japansupport@lexarmedia.com...
  • Page 11: Notes

    Notes: 9 9 9 9...

Table of Contents