Table of Contents
Advertisement
BCD-RGD-402P-uMT
Step 1: Remove the guide rail fastener.
Step 2: Remove the DIN clamp in the rear panel.
Step 3: Find the wall mounting accessory,
and loosen these 4 screws in the Swtich.
Step 4: Mounting the accessory on the rear panel.
Step 5: Fixed the switch on the wall.
4.3 items for attention
− Operating Ambient: If the product is installed in a closed rack, the inside operating ambient temperature of
the rack may be higher than outside. Therefore, consideration should be given to installing the equipment in
an environment compatible with the maximum operating temperature specified by the manufacturer.
− Air Flow: Installation of the equipment in a rack should be such that the amount of air flow required for safe
operation of the equipment is not compromised.
− Circuit Overloading: Consideration should be given to the connection of the equipment to the supply circuit
and the effect that overloading of the circuits might have on overcurrent protection and supply wiring.
− Reliable Earthing: Reliable earthing of rack-mounted equipment should be maintained. Particular attention
should be given to supply connections other than direct connections to the branch circuit (e.g. use of power strips)."
4.4 Grounding
Grounding and wire routing help limit the effects of noise due to electromagnetic interference (EMI). Run the ground
connection from ground screw to the grounding surface prior to connecting devices.
Industrial Gigabit Ethernet Switch with PoE+
6 ports: 4 PoE+ ports, 2 optical uplink ports
Step 1
Step 2
7
Advertisement
Table of Contents
