Voice Recognition; Using Voice Recognition - Chevrolet Camaro MyLink Infotainment System 2017 Manual

46

Voice Recognition

Voice Recognition
Voice recognition allows for
hands-free operation within the
navigation, audio, phone, and
weather applications. This feature
can be started by pressing
steering wheel controls or by
g
touching on the infotainment
display.
However, not all features within
these areas are supported by voice
commands. Generally, only complex
tasks that require multiple manual
interactions to complete are
supported by voice commands.
For example, tasks that take more
than one or two button presses such
as selecting a song or artist to play
from a media device would be
supported by voice commands.
Other tasks, like adjusting the
volume or seeking up or down are
audio features that are easily
performed by pressing one or two
buttons, and are not supported by
voice commands.
In general there are flexible ways to
speak commands for completing the
tasks. Most of them, except
destination entry and voice keypad,
can be completed in a single
command. If the task takes more
g
than one command to complete, the
on the
first command should be to indicate
the kind of task to be performed, like
Navigation Destination Entry. The
system replies with prompts that
lead you through a dialogue to enter
the necessary information. For
example, if a destination for route
guidance is needed, say
Navigation or Destination Entry.
If your language supports it, try
stating a One-Shot command, such
as Navigate to Address one two
three Main Street, Lansing
Michigan. This type of destination
entry command is supported in
some languages. Another example
of a One-Shot Destination Entry
command is, Navigate to Place of
Interest Hotels. If these
commands do not work, try saying,
Navigate to Place of Interest or
Navigate to Address and the
system will do the rest.
Voice recognition can be used when
the ignition is on or when Retained
Accessory Power (RAP) is active.
See Retained Accessory Power
(RAP) in the owner manual.

Using Voice Recognition

Voice recognition becomes available
once the system has been
initialised. This begins when the
ignition is turned on. Initialisation
may take a few moments.
g
1. Press on the steering wheel
controls to activate voice
recognition, or touch
infotainment display.
2. The audio system mutes and
the system plays a prompt
followed by a beep.
3. Wait until after the beep
completes, then clearly speak
one of the commands
described in this section.
g
Press to interrupt any voice
recognition system prompt. For
example, if the prompt seems
g
on the