MM MI114 User Manual page 17

Batching controller
Table of Contents

Advertisement

13
[t2
**]
14
[t3
**]
15
[t4
**]
16
[t5
**]
17
[t6
**]
18
[Prt
*]
Mode 3 (Catch Weighing Mode)
Para-
Indicator
meter
Display
3
[FodE *]
4
[H******]
5
[L******]
6
[Lq*****]
7
[t0
**]
8
[t1
**]
MI114 Manual
0.0~9.9 seconds material 2 feed over
delay
0.0~9.9 seconds gradual feed output
time
0.0~9.9 seconds gradual feed interval
time
0.0 ~ 9.9 seconds discharge finish
delay
0.0~9.9 seconds re-feed delay
Whether to print this parameter:
0: No.
1: Yes.
Parameter Specification
Catch Weighing Mode:
0-Self-testing mode
1-External control mode
2-Upper and lower limit mode
Upper limit setting: Input a weight
value that is between zero and full
range.
Lower limit setting: Input a weight
value that is between zero and full
range.
Zero zone
Judgment Delay (0~9.9) Seconds:
At external control mode, data
calculation is conducted only after the
external control is triggered for t0
second;
At self-checking mode, data
calculation is conducted after the
weight leaves zero zone for t0 second.
Calculation
Time
Weight (0~9.9) Seconds:
The indicator will accumulate,
average the weight within t1 after t0,
and the obtained value will serve as
catch weighing basis.
This item won't be displayed when there is no
gradual feed.
It won't be displayed when there is no gradual
feed.
It won't be displayed when there is no printer.
Remarks
Self-testing mode: When the weight is greater
than zero zone value, it starts catch weighing
automatically.
External control mode: Only when the
external control signal is triggered, the
indicator begins catch weighing.
Upper and lower limit mode: The real-time
upper, medium, lower limit relay output.
When the weight value is smaller than the
lower limit, O1 is output;
When the weight value is between the lower
limit and upper limit, O2 is output;
When the weight value is greater than the
upper limit, O3 is output.
1. Enter the next cycle only after sending out
the catch weighing signal and the indicator
weight is less than this value;
2. Enter t1 only when the indicator weight is
greater than this value at self-checking mode.
for
Average
15

Advertisement

Table of Contents
loading

Table of Contents