Advertisement
Available languages
Available languages
ASSEMBLY INSTRUCTIONS (CONT.)
12. Insert BACK BOTTOM PANEL, P12, with unfinished side down, into lower grooves of SIDE APRONS, P7L and P7R.
Slide P12 forward until the end is flush with SIDE APRON ends below gear hinges, as shown in Figure 6.
13. Insert BACK TOP PANEL, P11, with finished white side up, into upper grooves of SIDE APRONS, P7L and P7R.
Make sure the end of P11 with the cutouts is on the same end as gear hinge as shown in Figure 6. Slide P11 forward until
the end with cutout is flush with SIDE APRON ends above gear hinges. With help from another adult, hold this assembly
firmly and attach pieces together using (3) SCREWS, H1, and pre-drilled holes on each side.
P7R
Figure 6
Slide both
panels in grooves
H1
Note: Location
of gear hinge
P7L
White side up
P11
P12
Note: Location
of these cutouts
8
Advertisement
