Advertisement
Available languages
Available languages
ASSEMBLY INSTRUCTIONS (CONT.)
18. With the help of another adult, set both completed assemblies upright and position so gears face each other as shown
in Figure 8. Using (2) HINGE SETS, P16, connect assemblies using BOLT, H5, and Washer, H7, as shown in Figure 8.
The bolts should be snug, but NOT over tightened as this is a pivot area. Note: Hinge gear assemblies must mesh together,
per diagram, and there should be no gap between playfields. Also, only one hinge plate per set is threaded and must be
installed on the inside of each playfield side.
19. Attach TRIANGULAR PATCH, P24, on each side aprons using (2) BOLTS, H4, and (2) WASHERS, H6, on each patch,
as shown in Figure 8.
20. Place TARGET BOARD, P15, with red hole at the top, into position with the sides resting in the grooves of the braces
on the side panels and against the front of the ramp.
21. Attach the RESET BUTTON, with the long white wire, through the hole in the FRONT END APRON, P5, by removing
the washer and nut on the back of the Reset Button, feeding the Reset Button and wire through the hole from the front and
re-attaching the washer and nut. Note: Be careful not to damage or break wire connections while attaching Reset Button.
Bundle of
Reset Button -
White Wire
(this ships
pre-wired to
Target Board)
P24
H6
H4
Ligature
Figure 8
P24
Note: Hinge Gear Assemblies Must Mesh
P15
Note: This Hinge is Threaded and Must Be on Inside
Note: This Hinge is NOT Threaded
and Must Be on Outside
P7R
Back Side
Apron
P16
Hinge Set
No Gap
No Gap
CAUTION:
Pinch Point
H5 Bolt
P16
Hinge Set
H7
Washer
P6R
Front Side
Apron
H7
Washer
CAUTION:
Pinch Point
P5
Reset Button
P5
Reset
Button
10
Advertisement
