Controls; Standby Mode - Kenwood KRF-V7771D Service Manual

MUTE indicator
MUTE
ST.
TUNED
Stereo indicator
TUNED indicator
ON/STANDBY
POWER
ON OFF
1 2 3
1 POWER key
Press to switch the main power ON and OFF.
2 ON/STANDBY (
)key
Press to switch the power mode between
STANDBY and ON.
3 Standby indicator
Lights in standby mode.
4 Remote sensor
Receives signals transmitted from the re-
mote control unit.
5 PHONES jack
Use for listening to audio through headphones.
6 SPEAKERS keys
Press each key to switch the SPEAKERS A or
SPEAKERS B ON and OFF.
7 Indicators
CLIP INDICATOR :
Lights when the input is clipped during
analog to digital signal conversion.
DOLBY DIGITAL :
Lights when Dolby Digital is activated.

Standby mode

While the standby indicator of the unit is lit, a small amount of current is flowing into the unit's internal circuitry to back up the memory. This
condition is referred to as the standby mode of the unit. While the unit is in the standby mode, it can be turned ON from the remote control unit.

CONTROLS

Multi-mode display
CLIP INDICATOR DOLBY DIGITAL
A
SPEAKERS
B
PHONES
4 5 6 7 8
MPEG :
Lights when the MPEG is activated.
Cinema Re-EQ :
Lights when the Re-EQ is activated.
8 MUTE key
Press to mute the audio temporarily.
9 Remote transmitter
Sends signals to the remote control unit.
0 Communication indicator
Lights when signal is input from or output to
the remote control unit.
! VOLUME control knob
Rotate to adjust the volume.
@ S VIDEO input jack (AV AUX)
Connect the S VIDEO output jack of an AV
component.
# VIDEO input jack (AV AUX)
Connect the composite video output (RCA)
jack of an AV component.
KRF-V7771D/V7771DE
Display
MPEG Cinema Re-EQ
VOLUME
INPUT SELECTOR
MUTE DISPLAY MODE
DOWN UP
S VIDEO
9 0 ! @ #
CD2 / TAPE2
MONITOR
V AV AUX L-AUDIO-R
$ % ^ &
$ AUDIO (L, R) input jacks (AV AUX)
Connect the audio output (RCA) jacks of an AV
component.
% CD2/TAPE2 MONITOR indicator
Lights when the CD2/Tape2 (Monitor) input is
used.
^ DISPLAY MODE key
Press to switch the display on the receiver.
Press for more than 2 seconds to switch the
recording mode.
& INPUT SELECTOR key
Press to switch the input as shown below.
TUNER
CD1
MD/Tape1
VIDEO1
VIDEO2
VIDEO3
VIDEO4
AV AUX
PHONO
3