Controls - Kenwood KRF-V7771D Service Manual

QQ
3 7 63 1515 0
TUNED indicator
POWER
ON/STANDBY ON/STANDBY
POWER
ON OFF
TE
L 13942296513
1 2
1 POWER key
(U.S.A., U.S.Military and Canada)
Press to switch power ON and OFF.
2 POWER key
(Except for U.S.A., U.S.Military and Canada)
(China : POWER)
Press to switch the main power ON and OFF.
3 ON/STANDBY key
(Except for U.S.A., U.S.Military and Canada)
Press to switch the power mode between
STANDBY and ON.
4 STANDBY indicator
Lights in STANDBY mode.
5 RC sensor
Receives signals transmitted from the re-
mote control unit.
6 PHONES jack
Use for listening audio through headphones.
7 SPEAKERS keys
Press each key to switch the SPEAKERS A or
SPEAKERS B ON and OFF.
www
.
STANDBY indication
While standby indicator is indicated, a small amount of power is supplied to the system to back up the memory. In this mode, the system can be
turned ON by remote control.
MUTE indicator
MUTE
ST.
TUNED
Stereo indicator
CLIP INDICATOR
SPEAKERS
PHONES
3 4 5 6 7
8 Indicators
CLIP INDICATOR :
Lights when the input is clipped during
analog to digital signal conversion.
DOLBY DIGITAL :
Lights when Dolby Digital is activated.
DTS :
Lights when the DTS is activated.
9 MUTE key
Press to mute the audio temporarily.
0 RC transmitter
Sends signals to the remote control unit.
! Indicator
Lights when signal is input from or output to
the remote control unit.
@ VOLUME control knob
Rotate to adjust the volume.
# S VIDEO input jack
(Except for the VR-2080 or the KRF-V7771D
for the U.S. Military destination)
Connect the S VIDEO output jack of an AV
component.
x ao
y
i
KRF-V7771D/V8881D/VR-2080/2090

CONTROLS

8
Multi-mode display
Display
DOLBY DIGITAL DTS
VOLUME INPUT SELECTOR
A
MUTE DISPLAY MODE
B
DOWN UP
Q Q
3 6 7 1 3
8 9 0 ! @
u163
.
2 9 9 4 2 8
CD2 / TAPE2
MONITOR
S VIDEO V L - AUDIO - R
AV AUX
1 5 0 5 8 2 9 9 4
# $ % ^ & *
$ VIDEO input jack
Connect the composite video output (RCA)
jack of an AV component.
% AUDIO (L, R) input jacks
Connect the audio output (RCA) jacks of an AV
component.
^ CD2/TAPE2 MONITOR indicator
Lights when the CD2/Tape2 (Monitor) input is
used.
& DISPLAY MODE key
Press to switch the display on the main unit.
* INPUT SELECTOR key
Press to switch the input as shown below.
TUNER
CD1
MD/Tape1
VIDEO1
VIDEO2
VIDEO3
VIDEO4
AV AUX
PHONO
m
co
9 9
2 8 9 9
3