Section 6: Drive Fault Monitoring - Quartech 2800 Product Manual

Page 21
Section 6:
Drive Fault Monitoring
The 2800 can be configured to automatically trigger a screen when a drive fault occurs. Up to six drives can be
monitored. Every five seconds the 2800 will issue a drive status request. When multiple drives are assigned the
2800 will rotate through the assigned nodes, one every five seconds. If a drive is reported to be faulted then the
associated screen will be triggered using screen trigger number two.
The 2800 uses the ULTRA 3000 default setting: 8 Data bits, No Parity, 1 Stop bit. The baud rate is selectable
between 9600bps, 19,200bps or 38,400bps.
PM2800U3K Revision 4