Advertisement
LED Indicator
LED
Power
Run
Reset Button
If need to restore the Access Controller into factory default, please do
following procedure: Power on AC Controller, use a pin to press and hold
the reset button until all LED becomes quick-flash.
Then release the button and wait for AC Controller to reset to factory
default setting. After reset, the default IP address of Access Controller is
192.168.10.1, default user name and password are admin.
RJ45 Connector
5 x 10/100M/1000Mbps auto-negotiation RJ45 Ethernet Port
Notice :
LAN/WAN port is LAN port only on the default mode, only when WAN
setting is enabled then LAN/WAN port will change to WAN port.
2.1.2 Rear Panel
DC Connector
DC Connector located on the right side of Access Controller's rear panel,
input power is AC 100-240V~ 50/60Hz 0.3A
Grounding For Lightening
Please deploy ground connection to avoid lightening stroke, detail
installation please refer to "Grounding For Lightening Guide".
3. Login
Please make sure the following items before login the Access Controller.
Name
Power is ON, means status is up
Power is OFF, mean status is
Power Light
down
Flashing, means system status is
normal
System Light
OFF or Solid, means status is
abnormal
2
Indication
www.nc-link.cn
Advertisement
