Advertisement
firmware, do not power off, otherwise it may damage the Access Controller！
System Time
Synchronization with the host
Synchronization time with connected PC and router
Status
Enable or Disable NTP
NTP Server
Select the server time synchronization
Custom NTP Server
Setting user-defined synchronization server IP address
Time Zone
Setting the router's time zone
5. Trouble Shooting
Q1: Controller can't found APs when AP connect with controller
An: The controller automatically discovers APs, APs will be detected and shown
on the list within one minute. And make sure the AP and controller are in the
same subnet.
Q2: Which APs can apply the Zero Config?
An: Except the APs in "Device Group", other AP will apply Zero Config once
detected by controller.
Q3: Current APs configuration don't change after change the Zero Config setting
www.nc-link.cn
26
Advertisement
