Cisco MWR 1941-DC User Manual page 16

Configuring Tasks
Command
Step 5
Router(config-if)# standby group track multilink
number decrement-value
Router(config-if)# standby group track loopback
number decrement-value
Router(config-if)# standby group track fastethernet
number decrement-value
Step 6
Router(config-if)# standby group priority 100
If you are using the MWR 1941-DC in a redundant configuration, you must also set the keepalives under
Note
the FE interface to 1.
Router(config-if)# keepalive 1
Enabling the FE Interface
Once you have configured the FE interface, you can enable it.
To enable the FE interface, use the following command while in interface configuration mode:
Command
Router(config-if)# no shutdown
16
Cisco MWR 1941-DC Router with the Cisco IOS IP-RAN Feature Set
Purpose
Specifies other interfaces on the router for the HSRP
process to monitor in order to alter the HSRP priority
for a given group.
When using the MWR 1941-DC router in the CDMA
IP-RAN solution, you must configure each FE
interface to track the multilink interface, the
loopback interfaces, and the other FE interface.
In redundant configurations, you should issue
Note
standby track commands for both the health
interface (loopback101) and the revertive
interface (loopback102) as well as for the
backhaul interface (multilink1). The
decrement values must be as follows: 10 for
the multilink, FE, and health interfaces; 5 for
the revertive interface.
Configures HSRP priority.
We recommend that you specify a priority
Note
of 100.
Purpose
Enables the interface.