ActionTec SBT200DI User Manual page 3

FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that
this device does not cause harmful interference
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This Mobile Phone meets the government's requirements for exposure to radio waves. The
guidelines are based on standards that were developed by independent scientific organizations
through periodic and thorough evaluation of scientific studies. The standards include a
substantial safety margin designed to assure the safety of all persons regardless of age or
health.
FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg
averaged over one gram of tissue. Device types: (FCC ID: LNQSBT200DI) has also been
tested against this SAR limit
According to this standard, the highest SAR value reported during product certification for
body use is 0.654 W / kg,
The device was tested for typical bodily operations where the product was kept 5 mm from
the body. To maintain compliance with FCC RF exposure requirements, use accessories that
maintain a separation distance of 5 mm between the user's body and the back of the phone.
The use of belt clips, holsters and similar accessories shall not contain metal parts in its
assembly. Use of accessories that do not meet these requirements may not comply with FCC
RF exposure requirements and should be avoided.
Body wear operation
The device was subjected to a typical body manipulation test. In order to comply with RF
exposure requirements, a minimum separation distance of 0.5 cm must be maintained between
the user's body and the product (including the antenna). The accessories used in this
equipment should not contain any metal parts. Body wearing accessories that do not meet
these requirements may not meet RF exposure requirements and should be avoided. Use only
the supplied or approved antenna.
FCC ID: LNQSBT200DI