Operating Instructions; Using Your Product; Cleaning & Maintenance; Taking Care Of Your Product - NewAir WindPro18W Owner's Manual

OPERATING INSTRUCTIONS

USING YOUR PRODUCT

Always operate the fan in the upright position following all instructions and
recommendations listed in this manual.
1. Plug the power cord into a 120 volt power source. Be sure plug fits
tightly in outlet. A loose connection may cause overheating and
damage to the plug or fan.
2. Adjust the position of the yoke and tilt the fan head to direct the
breeze where needed.
3. Select the desired fan speed setting, or turn the unit OFF using the
rotary dial on the inline controller.
L = Low
Warning: To prevent overloading a circuit, do not plug the fan into a circuit that
is servicing other electrical needs.
CLEANING & MAINTENANCE

TAKING CARE OF YOUR PRODUCT

1. Always disconnect the fan from the main socket before cleaning.
2. Clean the grille surface with a clean damp cloth. Do not use harsh
chemical or abrasive cleaners.
3. Wipe the blades and grills with a soft, damp cloth.
4. Snap the front grill back into place to reassemble the fan.
5. Replace front grille before fan use. Allow fan to dry completely before
use. Periodic grille cleaning with a vacuum will prevent dust build up.
The motor is sealed and does no require any interior maintenance,
cleaning or lubrication.
6.
DO NOT IMMERSE THE FAN OR ANY WIRES IN WATER.
7. The internal motor bearings are permanently lubricated at the factory
and do not require any additional lubrication.
8
M = Medium
http://www.NewAir.com
H = High