Unpairing The Remote With The Led Bulbs; Activate Night Light; Activate Full Warmwhite Light - ADJ COLOR STRAND LED User Instructions

UNPAIRING THE REMOTE WITH THE LED BULBS

If you want to change the paired zones of a color strand or multiple color strands to configure another setup,
follow these instructions :
1) Fix all the LED bulbs in their lamp holder and connect the strand to a power outlet. Disconnect the
strand and reconnect it after 10 seconds.
2) Now, press and hold or the Group Lamp ON button
The LED bulbs will flash fast 9 times to confirm a succesfull unpairing.
3) Now you can pair the LED bulbs again to another group like explained on page 6.
Note：If you want to unpair all the LEDs of all zones, Disconnect the strand and reconnect it after 10
seconds, then press and hold the „ALL ON" button
All LED bulbs will flash fast 9 times to confirm a succesfull unpairing.

ACTIVATE NIGHT LIGHT

The NIGHT LIGHT Mode allows you to put all LEDs in Night Light Mode, with RGB LEDs OFF and WW-LEDs
set to 2% brightness of its maximum brightness.
1) White running normally, press and hold the "ALL OFF" button
2) You can also set a group to NIGHT LIGHT Mode by pressing and holding the corresponding Group
Lamp OFF button

ACTIVATE FULL WARMWHITE LIGHT

To activate full brightness of the WW-LEDs :
1) Press and hold the "ALL ON" button
Brightness.
2) You can also set a group to full brightness by pressing and holding the corresponding Group Lamp
ON button
A.D.J. Supply Europe B.V. – www.americandj.eu – Color Strand LED Instruction Manual Page 7
you want to unpair.
to put brightness of all Warmwhite LEDs to 100%
to activate NIGHT LIGHT.