Safety Precautions; Set Up; Dimensions - ADJ COLOR STRAND LED User Instructions

SAFETY PRECAUTIONS

• To reduce the risk of electrical shock or fire, do not expose this unit continuously to rain or moisture
• This unit is rated IP44 : Protected against water splashing the enclosure from any direction
• Do not attempt to operate this unit if the power cord has been frayed or broken. Do not attempt to remove or
break off the ground prong from the electrical cord. This prong is used to reduce the risk of electrical shock and
fire in case of an internal short.
• Disconnect from main power before making any type of connection.
• Do not remove the lamp cover under any conditions. There are no user serviceable parts inside.
• Never operate this unit when it's cover is removed.
• Never plug this unit in to a dimmer pack
• Always be sure to mount this unit in an area that will allow proper ventilation. Allow about 6" (15cm) between
this device and a wall.
• Do not attempt to operate this unit if it becomes damaged.
• During long periods of non-use, disconnect the unit's main power.
• Always mount this unit in safe and stable matter.
• Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed
upon or against them, paying particular attention to the point they exit from the unit.
• Cleaning -The fixture should be cleaned only as recommended by the manufacturer. See page 8 for cleaning
details.
• Heat -The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or
other appliances (including amplifiers) that produce heat.
• The fixture should be serviced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the appliance.
C. The appliance does not appear to operate normally or exhibits a marked change in performance.

SET UP

Power Supply: The ADJ Color Strand LED's power supply auto-senses the voltage when it is plugged into the
power source. With this automatic voltage recognition there is no need to worry about the correct power voltage,
this unit can be plugged in anywhere from 86V-265V 50/60Hz
Operation temperature of the LEDs is between -40°C – 60°C.
! CAUTION : ONLY PLUG INTO POWER OUTLET WITH ALL 20 LED BULBS SCREWED INTO THE E27
LAMP HOLDERS. RISK OF ELECTRICAL SHOCK !

DIMENSIONS

REMOTE
A.D.J. Supply Europe B.V. – www.americandj.eu – Color Strand LED Instruction Manual Page 5