Related Manuals for SLIDE SW200
Summary of Contents for SLIDE SW200
- Page 1 SMARTWATCH SW200 Quick Start Guide Please read this manual before use. Visit us at www.slideusa.com or contact us at support@slideusa.com...
-
Page 2: Safety Warning
SAFETY WARNING • Please charge the watch for at least two hours prior to its first use. • If prompted for a password, enter “1122.” This is the default password. You can change the password under Settings, in the Security Settings menu. PRODUCT DETAILS Power Button: Power the watch On/Off, turn the screen On/Off, or... -
Page 3: Quick Controls
QUICK CONTROLS • Slide the screen to the left to change to the next page. • Slide the screen to the right to return to the previous page. • Swipe from the top of the screen to the bottom to bring up the Settings menu. -
Page 4: Basic Functions
FOR IOS PHONES: Turn on Bluetooth ® on both the watch and the phone. Then, from the watch, go to the Bluetooth option in the menu and ® touch “Search for New Device.” Locate your phone, and connect the two. Make sure to allow the Phone Book to be shared, as that will help with displaying incoming notifications. - Page 5 You will see a sliding metal fixture for the SIM Card. Slide it to Open and insert the SIM Card. Next to the SIM Card slot is a place for the MicroSD Card.
-
Page 6: Troubleshooting
NOTES • It usually takes about 1-2 hours to achieve a full charge. • Use the included cable and charger to charge the watch. You can use your Android ac- cessories with the watch. • Bluetooth will disconnect when ® the phone is too far from the watch. - Page 7 Usage Time is Short • The battery may not be adequately charged. Charge the watch fully. • When using a SIM Card, the power may run out quickly if the signal is poor. Move to a location with better signal. Unable to Charge •...
- Page 8 FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
- Page 9 Your wrist watch is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population.
Need help?
Do you have a question about the SW200 and is the answer not in the manual?
Questions and answers