Table of Contents
Advertisement
G E T T I N G
S T A R T E D
2.5 The Signal Hound Front & Rear Panels
The front panel includes a 50
RF input. Do not exceed +20 dBm or
damage may occur.
BUSY LED flashes orange each time a
command from the computer is
processed.
3) A multi-purpose BNC connector. This may be used as a TTL/CMOS trigger input,
a Self Test Signal output, a Tracking Generator Sync signal, or a generic CMOS Sync
Output. The Signal Hound software controls the function of this BNC. It defaults to
unused / no output.
SMA
A READY /
The rear panel has three connectors:
1) 10 MHz Reference input, automatically
detected after each sweep completes. Use a
clean 10 MHz reference with >0 dBm level.
+13 dBm is recommended.
2) A USB type B connector. Connect to
your PC using the included USB cable.
13
Advertisement
Table of Contents
