Advertisement
SHAPING THE
LIGHT WITH THE
BARNDOORS
The barndoors can be opened and closed
independently to prevent light from spreading
to unwanted areas, or to precisely control
where the light strikes.
SETTING
THE CHANNEL
The UTP-30B and UTP-60B feature a
2.4 GHz receiver that enables them to
be operated by the Genaray MB-WRT
wireless remote (included with UTP-60B).
The remote can control your lights from
up to 98 feet (30 m) away. The lights offer
99 channels for controlling setups with
multiple lights and preventing interference
from other remote devices in your area.
To set the channel, follow these steps:
1. With the light's power on, press and hold
the Mode button. The channel number will
appear on the screen without any mode
indicators. If one of the mode indicators
is visible, press and hold the mode button
again to enter channel selection mode.
2. Press and hold the + or - buttons
to increase or decrease the value.
Press either button to raise or lower
the value by one-unit increments.
3. Press the Mode button again to
exit channel selection mode.
The lights and the remote must be set to
the same channel. To set the channel on the
remote, refer to the user manual included
with the Genaray MB-WRT wireless remote.
Ultra Thin Bicolor SMD LED USER MANUAL
13
Advertisement
