Table of Contents
Advertisement
Charging the sub monitor station
1
Insert the battery. (For the VL-W617, first remove the battery cover.)
A Align the terminals and insert.
B Close the battery cover.
L T he battery level is displayed
as
.
2
Assemble the charger stand, and plug the AC adaptor into the power outlet.
N
To assemble the charger stand
A Plug the connector of the AC adaptor into the
jack on the charger.
L Y ou can pull out the AC adaptor cord to the
left or right side.
B Attach the charger stand.
A
B
N
To remove the charger stand
Pressing the tab, pull the charger stand to detach.
Tab
3
Place the sub monitor station on the charger and charge the battery.
While charging: The CHARGE indicator lights up.
When charging is complete: The CHARGE indicator turns off.
LAt the first time of charging or after battery replacement, it takes about 7 hours to complete charging.
LIf you use the sub monitor station while charging, the charging time becomes longer.
L L ocate the charger where "OUT OF RANGE" is not displayed on the sub monitor station.
(The charging time becomes longer where the sub monitor station is out of range of the main monitor station.)
L E ven after the sub monitor station is fully charged, the sub monitor station can be left on the charger without
any ill effect on the batteries.
Important:
L U se only the included AC adaptor.
L W hen the sub monitor station is off the charger or the AC adaptor is disconnected for 1 week or more, remove
the battery in order to maintain the battery performance and prevent the battery from discharging.
– Recharge the battery before using the sub monitor station again.
A
Terminals
Charge contacts
(Metallic parts)
Preparation
B
Do not remove the
pad at the back of
the battery cover.
Power outlet
AC adaptor
CHARGE indicator
Charge contacts
(Metallic parts)
5
Advertisement
Table of Contents
