Buffalo WLI-UTX-AG300 User Manual page 23

Chapter 3 Configuration
Parameter
a/g Switching Settings
Output Power
WMM
Multicast Conversion Request
Wireless Authentication
WLI-UTX-AG300 User Manual
Meaning
This specifies the band used when connecting with the wireless
access point.
Automatic (11a priority)
First, a connection is tried at 802.11a, and if a connection cannot
be made, a connection is tried at 802.11g.
This setting is enabled only when connected by AOSS.
Automatic (11g priority)
First, a connection is tried at 802.11g, and if a connection cannot
be made, a connection is tried at 802.11a.
This setting is enabled only when connected by AOSS.
11a only
Only 802.11a connections are allowed. Even if an 802.11a
connection cannot be made, 802.11g is not used.
11g only
Only 802.11g connections are allowed. Even if an 802.11g
connection cannot be made, 802.11a is not used.
This sets the output of the wireless signal. Because the wireless
transmission output and signal distance range are nearly
proportional, when the wireless transmission output is reduced,
the signal distance range also becomes shorter.
Set priorities for specific communications.
Specific multicast data (such as video broadcast data) can be
transferred at high speeds to an access point that supports the
multicast control.
Specifies an authentication method for wireless connections.
22