Landing And Engine Stopping; Landing; Engine Stopping - Yamaha RMAX Type II G Unit Operation Manual

Flying Procedure

Landing and Engine Stopping

Landing

Never allow anyone to approach within 20 m
of the helicopter.
After hovering the helicopter over the landing point,
gradually lower the throttle stick to land it.
After landing, turns the GPS control switch OFF.
If the engine speed does not lower within 3
seconds after landing, turn the YACS control
switch OFF. This will lower the engine speed
to idle.

Engine Stopping

1 After the engine speed has lowered, press down
the Engine Stop switch on the transmitter until
the engine comes to a complete stop.
2 Press the Rotor Brake switch.
Never approach (or allow others to approach)
within 20 m of the helicopter until the main
rotor has come to a complete stop and the
engine has stopped. Entering within 20 m of
the helicopter could cause a serious acci-
dent.
G Do not press the Engine Stop switch
before the engine speed has dropped.
G The rotor brake will not apply unless the
throttle stick is placed in the slowest posi-
tion.
3 Before turning OFF the main switch of the heli-
copter, check the self monitor's check point indi-
cator and the malfunction area indicator lights for
any illumination or flashing.
5-11
DANGER
TIP
DANGER
TIP
Throttle Stick
2
1