Mocka Designer Highchair Assembly Instructions

Enlarged version

Designer Highchair

Assembly Instructions

Thank you for your purchase.

Please follow the instructions below for correct assembly.

IMPORTANT!

KEEP FOR FUTURE REFERENCE:

WARNING: Never leave your child unattended in the

highchair. Strict adult supervision is required at all times.

WARNING: Ensure the safety strap is in use at all times to

avoid the child slipping downwards and causing injury. We

recommend the use of the shoulder and waist harness for

added safety and to avoid injury caused by falls – this is

available on our website.

WARNING: Do not use the highchair unless components are

correctly fitted and adjusted.

WARNING: Ensure the highchair is positioned away from

objects or structures that can cause injury. Be aware of the

risk of open fire and other sources of strong heat, such as

electric bar fires, gas fires etc, in the vicinity of the highchair.

The highchair should not be used until the child can sit up

unaided. Do not use the highchair if any part is broken, torn

or missing.

mocka.co.nz | mocka.com.au

Tray

Legs

Please note: the highchair has a one year

warranty. This warranty does NOT cover the

clips/prongs on the tray. Care must be taken when

inserting/removing the tray to avoid damage.

Seat

Table of Contents

Do you have a question about the Designer Highchair and is the answer not in the manual?

Page 1 Designer Highchair Assembly Instructions Thank you for your purchase. Please follow the instructions below for correct assembly. IMPORTANT! KEEP FOR FUTURE REFERENCE: Seat WARNING: Never leave your child unattended in the highchair. Strict adult supervision is required at all times.
Page 2 Designer Highchair Assembly Instructions Slot all four legs into the corners of the highchair seat. Press in spring Check all legs are attached and locked in place in the seat. button in the top of each leg and ensure it clicks into place in the hole in the seat.
Page 3 Designer Highchair Assembly Instructions Tray Tray Please make sure that the prongs on the tray are inserted holes located on the side of the highchair), then push the tray down to align with the chair. To remove, simply reverse the instructions, ie carefully lift the front of the tray, then remove.
Page 4 Designer Highchair Assembly Instructions Harness Harness A. Attach the anchor straps to the harness. Place the complete C. Carefully seat child in the highchair and slip arms and shoulders harness inside the seat of the highchair and push the two ends down through harness.