Settings Customer level
>> Extra hot water stop temperature
Factory setting
Lowest value
Highest value
Tab. 22 Hot water temperature
B Set the stop temperature for extra hot water.
The heat pump starts the function directly and uses first
the compressor and then the additional heat source for
the temperature increase. When the respective number
of hours have passed, the heat pump returns to normal
hot water mode.
DANGER: Risk of burn injuries.
B Use a mixing valve when the hot water
temperature exceeds 60 °C.
> Hot water peak
Hot water peak means a temporary increase in the hot
water temperature to approx. 65 °C for thermal
elimination of bacteria.
For the hot water temperature increase, the compressor
is used first; the additional heat source then continues
alone.
>> Day of the week
Factory setting
Area
Tab. 23 Weekday
B Set the day on which the hot water peak should take
place. None means that the function is disabled. All
means that a hot water peak takes place every day.
If hot water peak is deactivated comfort mode must
be selected in the menu Hot water mode.
>> Interval in weeks
Factory setting
Lowest value
Highest value
Tab. 24 Week interval
B Set how often a hot water peak should take place.
– 1 means a hot water peak every week.
– 2 means that a hot water peak takes place in all
even weeks of the year, i.e. in week 2, 4, 6, etc.
– 3 means week 3, 6, 9, etc.
– 4 means week 4, 8, 12, etc.
20
65 °C
50 °C
65 °C
Wednesday
None, Day, All
1
1
4
>> Start time
Factory setting
Lowest value
Highest value
Tab. 25 Start time
B Set the time of the hot water peak.
WARNING: Risk of burn injuries.
At hot water temperatures greater than
60 °C, there is a risk of burn injuries.
B Exercise caution when tapping hot water
immediately after a hot water peak.
> Hot water program
Program 1 and Program 2 enables you to block hot
water production during the set time.
>> Active program
Factory setting
Alternative
Tab. 26 Hot water program
>> View/edit active program
The menu is displayed only if Program 1 or Program 2
has been selected. Programs are changed in the same
way as for Room temperature program
( Chapter 10.2).
> Hot water mode
F value
Alternative
Tab. 27 Hot water mode
B Select hot water mode.
Economy means that the hot water is permitted to
cool slightly before hot water production starts
compared to Comfort. Heating stops at a slightly
lower temperature.
B Change to Comfort if more or hotter hot water is
desired.
This setting must be used if electric add. heat is
missing or if the hot water circulation is used, when
the temperature in the hot water circulation is
otherwise too low.
The factory settings for on and off temperature are
approx. 8 K lower in Economy mode compared to
3:00
0:00
23:00
Always hot water
• Always hot water
• Program 1
• Program 2
Economy
Economy/Comfort
6 720 643 415 (2010/03)
Need help?
Do you have a question about the Greenline HE C6-C11 and is the answer not in the manual?