Mounting Instructions - Balboa bba 2 Installation Manual

bba

2 Mounting Instructions

™
1 - Choose a well ventilated mounting surface. The bba2
amplifier generates significant heat when operating at
high power levels.
Mounting Screws
2 - To insure a good Bluetooth connection, the mounting
surface should be elevated from the ground.
45mm
3 - It is preferable to mount bba2 such that the heat sink
fins are vertical or facing upward.
9.5mm
4 - Drill pilot holes in the mounting surface that
correspond with the 2 mounting holes in the bba2
amplifier. Be sure not to drill into any critical areas
of the spa.
Mounting Holes
5 - Fasten the bba2 amplifier to the surface securely with
the mounting screws.
Heat Sink Fins
Continue to next page.
42296-D, bba2 Manual
© 2017 Balboa Water Group. Single Source Solution. All rights reserved.
1382 Bell Avenue | Tustin, CA 92780 | p 714.384.0384 | www.balboawater.com
Page 6
We reserve the right to change technical data without further notice.