Advertisement
www.electrolux.com
8
Connection in Extraction Mode
When installing in extraction mode, con-
nect the hood to the chimney using either
a flexible or rigid pipe ø 150 or 125 mm,
the choice of which is left to the installer.
• To install a ø 125 mm air exhaust con-
nection, insert the reducer flange G on
the hood body air outlet and the adapt-
ing ring ø120-125 F on the reducer
flange.
• Fix the pipe in position using sufficient
pipe clamps (not supplied).
• Remove any activated charcoal filters.
Connection in Recirculation Mode
• When the hood is fitted in the recircu-
lation mode the Air Outlet Connection
H should be fitted as illustrated .
• Fit the (optional) charcoal filters by
repeating the following operation on
each side of the motor housing. Place
the two key hole slots in the filter and
turn the filter clockwise to lock the filter
in position.
WARNING: It is a possible fire hazard if
the metal grease filters are not cleaned
and the charcoal filters replaced regu-
larly.
IMPORTANT:
When installing this product in recircula-
tion mode over a gas hob or Gas cooker
and between adjacent wall mounted
cupboards. The installer must ensure
that there is no gap between the edge of
the canopy and wall cup-boards.
Connections
ø120
ø125
G
F
G
H
15
ø150
B
A
Advertisement
