Sharp K-70V19BM2-EN User Manual page 10

followed explicitly during wiring:
– The grounding cable must be connec-
ted via the screw with the grounding
mark. The supply cable connection
must be carried out as shown in Fi-
gure 6. If there is no grounded outlet
conforming to regulations in the ins-
tallation environment, call the Authori-
zed Service Centre immediately.
– The grounded outlet must be in close
proximity to the appliance. Never use
an extension cord.
– The supply cable should not contact
the product's hot surface.
– In the event of any damage to the
supply cable, make sure to call the
Authorized Service Technician. The
cable must be replaced by the Autho-
rized Service technician.
– Wiring of the appliance must be per-
formed by the Authorized Service
technician. A H05VV-F type supply
cable must be used.
– Faulty wiring may damage the appli-
ance. Such damage will not be cove-
red under the warranty.
– The appliance is designed to connect
to 220-240V~. If the electricity is diffe-
rent than the value given above, call
the Authorized Service Centre imme-
diately.
– The manufacturer declares that its
bears no liability of any kind for
damage and loss arising from not
complying with safety standards!
– Wiring of the appliance must be per-
formed by the Authorized Service
technician. The appliance is
– designed to connect to 220-240V~
electricity. If the electricity power line
is different than the value given, call
the Authorized Service Centre imme-
diately. The appliance is designed for
using with a plug or fixed connection
to the power line. It is necessary that
you install a double pole switch bet-
ween the product and the electricity
supply (power line), with a minimum
gap of 3 mm between the switch con-
tacts. (20A rated, delayed function
type).
3.4. GENERAL WARNING AND
PRECAUTIONS
Your appliance is produced in confor-
mity with the relevant safety instruc-
tions relating to electrical appliances.
Maintenance and repair works must be
performed only by Authorized Service
technicians trained by the manufactu-
rer. Installation and repair works, per-
formed without observing the rules may
be hazardous.
The outer surfaces is heated while your
appliance is in operation. The elements
heating the inner surface of the oven
and the steam coming out of the oven
10