LampSite
Installation Guide
Figure 4-26 Installing an RHUB on a wall
----End
4.4 Installing RHUB Cables
This section describes how to install cables for an RHUB.
4.4.1 Requirements for Cable Layout
Cables must be routed according to the specified cabling requirements to prevent signal
interference.
General Requirements for Cable Layout
Bending radius
Issue 02 (2014-05-27)
NOTE
As shown in the preceding figure, when the RHUB is placed against the wall, ensure that the RHUB panel
is vertical to the ground and the PSU is on the lower part of the RHUB panel.
NOTE
If a cable listed below is not required, skip the requirements for routing the cable.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Installing an RHUB
28