Table of Contents
Advertisement
4-5
Module Fail / Problem
Remedy / Symptom
Load any disc always show "No disc", this could be a bad DVD drive
Load some kind of discs always show "No disc". For example load DVD no
problem, but load CD-R show "No disc", this could be a bad DVD drive
DVD Drive
Cannot open tray. User can try to power off the recorder, and then press
"Eject" to boot again. If still can not open, this could be a bad DVD drive.
If tray open successfully and there is a disc inside, it's the disc cause drive
busy. Try another disc, if user can tray in/out no problem, the drive should
be ok.
Run Disc Tool/Format/DVD show "Fail". This could be a bad disc or not
compatible with our DVD drive.
Format no problem but show "Write Fail" then stop during recording. Press
"Record" again may be user can continue record, but part of the
DVD/CD disc
audio/video on this disc may not smooth. This could be a bad disc or not
compatible with our DVD drive.
Take long time to load disc then show "Invalid Disc". The disc could be a
bad disc or unsupported format
Connect power cord, but LED display show nothing, Press remote or
button on the panel still nothing happened. This could be a power board
Power
problem
Replace power cord if find any available. We use a common power cord
user may able to find the same one on his other electronic products
Press buttons on remote but nothing happened, system can still power on
Remote
by buttons on panel. OSD doesn't show system receive any key. This
could be a bad remote or ran out of battery.
Or it could be a bad receiver on the front panel
Front Panel
System can power on and work by remote no problem, but press buttons
on panel does not work. This could be a bad front panel
Advertisement
Table of Contents
