Speaker Disassembly; Radio Reassembly - Detailed; Speaker Reassembly; Figure 7-49. Speaker Removal - Motorola EP350 Basic Service Manual

Maintenance – EP350 (Limited Keypad Model): Disassembling and Reassembling the Radio

7.5.1.4 Speaker Disassembly

1. Remove the screw holding the Speaker Retainer (10) to the Front Housing with a Phillips
screwdriver.
2. Remove the Speaker Retainer from the Housing.
Note: Be careful not to damage the Speaker Wire when removing the Retainer Bracket.
3. Remove the Speaker from the Housing with a flat head screwdriver.
4. Remove the Speaker Insulator (11) from the speaker.
5. Remove the Speaker Felt (8) from the grille area (Refer Figure 7-49).
Speaker Retainer
Speaker Insulator
Speaker
Speaker Felt
7.5.2 Radio Reassembly – Detailed

7.5.2.1 Speaker Reassembly

1. Place the Speaker Felt (8) onto the grille area.
2. Align the speaker wire at three o'clock position and push down the speaker until fully adhere onto
the front housing.
3. Align the Speaker Insulator (11) at twelve o'clock position and push down until fully adhere onto
the speaker.
4. Install the Speaker Retainer (10).
5. Tighten the Speaker Retainer to the housing with a Phillips screwdriver torque to (Refer Table 7-
16 on page 7-18 for torque in other units)

Figure 7-49. Speaker Removal

7-13