Table of Contents
Advertisement
6. prepArATIOn
6.1.
ATTACH THe GAS CyLInDer refer to fig.1.
6.1.1.
Position your gas cylinder at the side of your barbecue, not underneath, remember the cylinder must be kept away from heat, and be in
a safe position.
6.1.2.
Attach the regulator to the gas cylinder.
6.1.3.
Perform the Gas leak test as described in safety Precautions section 1.
6.1.4.
check that all areas under the front panel are free from any obstructions (insects etc.). this area must be kept clean as this may affect
the flow of combustion or of ventilation air.
6.1.5.
check the hose before each and every use, looking for cracks, cuts or any abrasions.
6.1.6.
if the hose is found to be faulty in any way, DO nOT attempt to use your barbecue, replace the hose with one from your sealey dealer.
6.1.7.
ensure the hose is free from any kinks or bends which will affect the gas flow, when using your barbecue. Also the hose must not have
undue tension and must not touch any part of the barbecue which may be hot. the hose must not be longer than 1.5 metres.
6.1.8.
When changing your gas cylinder ensure there are no sources of ignition nearby and make sure the barbecue is switched off.
6.1.9.
the barbecue must be kept away from flammable materials.
6.1.10.
DO nOT move the barbecue whilst in use.
7. LIGHTInG InSTruCTIOnS
WArnInG! the lid must be open when lighting the barbecue.
‰
WArnInG! DO nOT stand with your face directly over the barbecue when lighting it.
‰
7.1.
PILOT GAS CONTROL IGNITION Refer to figs.2, 3 and 4.
7.2.
make sure all gas controls on the barbecue are in the off position.
7.2.1.
turn the gas cylinder valve to the on position at the regulator.
7.2.2.
To create the spark press control knob A and hold it in for 3-5 seconds to allow gas to flow THEN turn ANTICLOCKWISE to HI (HIGH)
see fig.2B. It will then send a spark to the lighting tube C. A "snap" will be heard from the igniter and an orange flame will be seen
coming from the burner lighting tube at the left side of the burner d.
7.2.3.
continue to hold the burner control knob in for two seconds after the "snap", this will allow
gas to flow completely down the burner tube E and ensure ignition.
7.2.4.
When the burner is alight, adjacent burners will cross light when their controls are turned
to "Hi" (HiGH).
7.2.5.
At the HI (HIGH) setting the burner flame should be approximately 12 to 20mm long with
a minimum of orange flame.
7.2.6.
turn the gas control fully AnticlocKWise for the minimum setting.
WArnInG! if the burner does not light, turn the burner control knob to off and wait
‰
5 minutes to let the gas clear before lighting again.
© Jack sealey limited
fig.2
Original Language Version
fig.1
fig.3
fig.4
BBQ10 | issue 2(l) 25/09/17
Advertisement
Table of Contents
