Table of Contents
Advertisement
OPERATING CONTROLS
1
LED motor load
2
On/Off switch
3
Waterflow Indicator
4
GFCI protective switch
5
Grip
6
Hex collet
7
Water tap
8
Speed selection switch
9
Ventilation slots
10 Dry Drilling Kit
11 2nd Back Grip
12 Safety screw
13 Feed lever
14 Stand Grip
15 Rod with scale for drill angle adjustment
16 Locking screw
17 Clamping lever for 15
18 Guide block for BCR 130
19 Limit stop plate
20 Base plate
21 Adjusting screws
22 Safety bolt
23 Centering plate
24 Spindle nut
25 Screw assembly
26 Vacuumblock fastening screw
27 Connection for vacuum pump
28 Ventilating tap
29 Seal
30 Transportation wheels
31 Drill bit
32 Rubber cover
33 Fastening screw for water collecting ring
34 Water collecting ring
35 Clamping lever for Quick Release Guide
36 Safety bolt Quick Release Guide
37 Pressure gauge vacuum kit
38 Air vent
39 Filter cap
40 Vacuum gauge
41 Hose clip
42 Suction hose
43 Quick coupling
44 Fluid collecting container with float
45 Mains plug
46 Frame
47 Overload safety switch
*Not all of the accessories illustrated or described are
included as standard delivery .
®
BCR130/5-BCR164/6,5-BCR300/12
SAFETY GUIDELINES
The definitions below describe the level of sever-
ity for each warning. Please read the operating
manual and pay attention to these symbols.
DANGER: Indicates an imminently
hazardous situation which, if not
avoided, will result in death or seri-
ous injury.
WARNING: Indicates a potentially
hazardous situation which, if not
avoided, could result in death or
serious injury.
CAUTION: Indicates a potentially
hazardous situation which, if not
avoided, may result in minor or
moderate injury.
NOTE: Indicates a practice not
related to personal injury which, if
not avoided, may result in property
damage.
INTENDED USE
The machine is intended for drilling into concrete
and reinforced concrete, when being used in con-
junction with diamond core bits for wet drilling
and a suitable water supply. BCR130/5 can also be
used for dry drilling in masonry and other build-
ing materials with the dry drilling kit.
The vacuum pump is intended for the fixation of
drillstands Compact and Large. The pump is only
designed for sucking in air, and no other gases or
fluids.
For damage caused by usage other then
intended, the user is responsible.
BEFORE USE
When drilling through walls or floors, make
absolutely sure that there are no obstacles
in the adjoining rooms and cordon off the
building site. Prevent the drilling core from
falling.
BEAST CORE RIG OPERATING MANUAL
9
Advertisement
Table of Contents
